Design and experiment of independent Four-Wheel Drive system for electric vehicles
Tóm tắt: 0
| 
PDF: 1 
##plugins.themes.academic_pro.article.main##
Author
Từ khóa:
Arduino
BLDC
Electric vehicle
Independent Four-Wheel Drive
PID
Tóm tắt
This paper presents the design and experimental implementation of an independent Four-Wheel Drive (4WD) system for a low-speed electric vehicle, using four 350 W Brushless DC (BLDC) hub motors integrated directly into the wheels. Each motor is independently controlled by a PID controller and an Arduino Mega 2560 microcontroller, allowing precise speed regulation of each wheel. The speed feedback signals are obtained from the Hall sensors integrated within the motors, while the steering angle Encoder sensor and Hall-type throttle pedal sensor provide input data for calculating the reference speed of each wheel. Experimental results show that the PID controller implemented on the Arduino Mega 2560 is capable of effectively controlling the speed of all four wheels, ensuring stable vehicle operation. Although minor speed fluctuations occur due to load differences, the system responds well when transitioning from low to high speeds.
Tài liệu tham khảo
-
[1] S. Zhu and C. Lyu, Distributed Drive Control Technology of Hub Motor. Singapore: Springer Nature Singapore, 2025, doi: 10.1007/978-981-97-2922-7_1.
[2] M. Yıldırım, M. Polat, and H. Kurum, "A survey on comparison of electric motor types and drives used for electric vehicles", in Proc. 16th Int. Power Electron. Motion Control Conf. Expo. (PEMC), 2014, pp. 218–223, doi: 10.1109/EPEPEMC.2014.6980715.
[3] M. S. Kumar and S. T. Revankar, "Development scheme and key technology of an electric vehicle: An overview", Renewable Sustainable Energy Rev, vol. 70, pp. 1266–1285, 2017, doi: 10.1016/j.rser.2016.12.027.
[4] M. Mahmud, M. R. Islam, S. M. A. Motakabber, M. D. A. Satter, K. E. Afroz, and A. K. M. A. Habib, "Control speed of BLDC motor using PID", in Proc. 2022 IEEE 18th Int. Colloquium Signal Process. Appl. (CSPA), 2022, pp. 150–154, doi: 10.1109/CSPA55076.2022.9782030.
[5] Z. Adel, A. A. Hamou, and S. Abdellatif, "Design of real-time PID tracking controller using Arduino Mega 2560 for a permanent magnet DC motor under real disturbances", in Proc. 2018 Int. Conf. Electr. Sci. Technol. Maghreb (CISTEM), 2018, pp. 1–5, doi: 10.1109/CISTEM.2018.8613560.
[6] H. Wang, "Design and implementation of brushless DC motor drive and control system", Procedia Eng, vol. 29, pp. 2219–2224, 2012, doi: 10.1016/j.proeng.2012.01.291.
[7] M. Mosin, N. Popov, V. Anibroev, M. Vilberger, and E. Domakhin, “Engine power distribution system for four-wheel drive autonomous electric vehicle”, Energy Reports, vol. 9, Suppl. 1, pp. 115–122, 2023, doi: 10.1016/j.egyr.2022.10.388.
[8] K. Deepak, M. A. Frikha, Y. Benômar, M. El Baghdadi, and O. Hegazy, “In-wheel motor drive systems for electric vehicles: State of the art, challenges, and future trends”, Energies, vol. 16, no. 7, Art. no. 3121, 2023, doi: 10.3390/en16073121.
[9] O. Castro-Heredia, J. Linares-Flores, O.-D. Ramirez-Cardenas, G. Escobar-Valderrama, J. E. Valdez-Resendiz, and G. Curiel-Olivares, “Electronic differential speed control for a four in-wheel motors EV based on a multi-agent system”, in Proc. 2023 Int. Symp. Electromobility (ISEM), Monterrey, Mexico, 2023, pp. 1–7, doi: 10.1109/ISEM59023.2023.10334710.
[10] Z. Gmyrek, "Optimal electric motor designs of light electric vehicles: A review", Energies, vol. 17, no. 14, p. 3462, 2024, doi: 10.3390/en17143462.
[11] M. Yildirim and H. Kurum, "Electronic Differential System for an Electric Vehicle with Four In-wheel PMSM", in Proc. IEEE 91st Vehicular Technol. Conf. (VTC2020-Spring), Antwerp, Belgium, 2020, pp. 1–5, doi: 10.3390/en1714346.
[12] A. Vozmilov, L. Andreev, and S. Panishev, "The Development and Modeling of a Proportional Integral Controller for the Electronic Differential of an Electric Vehicle", in Proc. 2022 Int. Conf. Ind. Eng., Appl. Manuf. (ICIEAM), Sochi, Russian Federation, 2022, pp. 578–582, doi: 10.1109/ICIEAM54945.2022.9787188.
[13] M. Yıldırım, E. Oksuztepe, and H. Kurum, "Design of Electronic Differential System for an Electric Vehicle with Four Independently Controlled In-Wheel PMSM", Advances in Electrical and Computer Engineering, vol. 24, no. 1, pp. 23–32, 2024, doi: 10.4316/AECE.2024.01003.
[14] M. Mahmud et al., “Control BLDC Motor Speed Using PID Controller”, Int. J. Adv. Comput. Sci. Appl., vol. 11, 2020, doi: 10.1109/CSPA55076.2022.9782030.
Xem thêm
##plugins.themes.academic_pro.article.sidebar##
Đã Xuất bản
Feb 28, 2026
Download
Cách trích dẫn
Phong, P. Q., H. D. Liem, và D. V. Kien. “Design and Experiment of Independent Four-Wheel Drive System for Electric Vehicles”. Tạp Chí Khoa học Và Công nghệ - Đại học Đà Nẵng, vol 24, số p.h 1, Tháng Hai 2026, tr 1-6, doi:10.31130/ud-jst.2026.24(1).616E.
