Effect of loaded-pad thickness on the static behaviors of five-pad hydrodynamic journal bearings
Tóm tắt: 36
| 
PDF: 52 
##plugins.themes.academic_pro.article.main##
Author
Từ khóa:
non-uniform geometry
five-pad
journal bearing
static behavior
Tóm tắt
The use of tilting pad journal bearings (TPJBs) has increased in the recent past due to their stabilizing effects on the rotor bearing system. Most of the studies about steady state and dynamic behaviors of TPJBs are usually evaluated by means of thermohydrodynamic models assuming nominal dimensions for the bearing. However, machining errors could lead to actual bearing geometry and dimensions different from the nominal ones. In particular, for TPJB the asymmetry of the bearing geometry leads to unexpected behavior of the bearing. In this paper, effects of non-uniform clearance on TPJBs’ performances such as clearance profile, shaft locus, power loss, pad tilt angle, and pressure distribution are evaluated using an analytical model. The results show that effects of non-uniform clearance on static characteristics of TPJBs are considerable when evaluating the efficiency of the bearing in particular and system in general.
Tài liệu tham khảo
-
[1] Meherwan P.Boyce, "Bearings and Seals”, Gas Turbine Engineering Handbook (Fourth Edition), 2012, pp. 557-604.
[2] Dang, P. V., Chatterton, S., Pennacchi, P., Vania, A., Effect of the load direction on non-nominal five-pad tilting-pad journal bearings. Tribology International, Volume 98, 2016, Pages 197 – 211.
[3] Chatterton, S., Gheller, E., Vania, A., Pennacchi, P., Dang, P.V, “Investigation of PEEK Lined Pads for Tilting-Pad Journal Bearings”. Machines 2022, vol. 10.
[4] Dang, P.V, Chatterton, S., Pennacchi, P, “Static Characteristics of a Tilting Five-Pad Journal Bearing with an Asymmetric Geometry”. Actuators 2020, vol. 9, 89. https://doi.org/10.3390/act9030089
[5] Dang PV, Chatterton S, Pennacchi P, Vania A, Cangioli F, “Eccentricity measurements on a five-pad tilting pad journal bearing”. Proceedings of the 14th IFToMM World Congress, Taipei, Taiwan, October 25–30; 2015. doi: 10.6567/IFToMM.14TH.WC.OS14.020
[6] Dang PV, Chatterton S, Pennacchi P, Vania A, Cangioli F. “Behavior of a tilting–pad journal bearing with different load directions”, International Design Engineering Technical Conferences and Computers and Information in Engineering Conference, Paper No. DETC2015-46598; 2015. 8. doi:10.1115/DETC2015-46598
[7] Chatterton, S.; Pennacchi, P.; Vania, A.; Dang, P.V. “Cooled Pads for Tilting-Pad Journal Bearings”. Lubricants 2019, 7, 92. https://doi.org/10.3390/lubricants7100092
[8] Dang PV, Chatterton S, Pennacchi P, et al. “Behavior of tilting-pad journal bearings with large machining error on pads”. ASME Turbo Expo, Paper No. GT GT2016-56674, 13–17 June 2016, Seoul, Korea. DOI: 10.1115/GT2016-56674
[9] Chatterton, S.; Gheller, E.; Vania, A.; Pennacchi, P.; Dang, P.V. “Investigation of PEEK Lined Pads for Tilting-Pad Journal Bearings”. Machines 2022, 10, 125. https://doi.org/10.3390/machines10020125
[10] Abu-Mahfouz, I., and Adams, M. L., 2005, "Numerical Study of Some Nonlinear Dynamics of a Rotor Supported on a Three-Pad Tilting Pad Journal Beaing (TPJB)”, ASME Trans., 127, pp. 262-272.
[11] Strzelecki, "Dynamic characteristics of tilting 5-pads journal bearing with asymmetric support of pads”, Sixth International Conference on Rotor Dynamics (IFToMM), University of New South Wales, Sydney, Australia, 2002, pp. 807–814.
[12] Wilkes, J. C., and Childs, D. W., "Tilting Pad Journal Bearing - A Discussion on Stability Calculation, Frequency Dependence, and Pad and Pivot”, ASME J. Eng. Gas Turb. Power., ASME Trans., 2012, 134.
[13] Guo, H., Bao, J., Zhang, S., Shi, M. “Experimental and Numerical Study on Mixed Lubrication Performance of Journal Bearing Considering Misalignment and Thermal Effect”. Lubricants, 10(10), 2022, 262.
[14] Betti, A., Forte, P., Ciulli, E, “Turbulence Effects in Tilting Pad Journal Bearings: A Review”. Lubricants 2022, vol. 10.
[15] Vinh, D.P., Chatterton, S., Pennacchi, P. “Static and dynamic behaviors of a cylindrical hydrodynamic journal bearing operating at very low Sommerfeld numbers”. In: Uhl, T. (eds) Advances in Mechanism and Machine Science. IFToMM WC 2019. Mechanisms and Machine Science, vol 73. Springer, Cham. https://doi.org/10.1007/978-3-030-20131-9_380
[16] Wagner, L.F.; Allaire, P.E, “Tilting-Pad Journal Bearings-Frequency-Dependent Dynamic Coefficients and Pivot Flexibility Effects”, Lubricants, 9(3), 2022, 26.
[17] Buchhorn, N., Stottrop, M.; Bender, B. “Influence of Active Cooling at the Trailing Edge on the Thermal Behavior of a Tilting-Pad Journal Bearing”, Lubricants 2021, vol. 9.
[18] Pennacchi P., Vania A., Chatterton S., Pesatori E., "Case History of Pad Fluttering in a Tilting-Pad Journal Bearing”, of ASME Turbo Expo, Glasgow, UK, 2010.
[19] Hargreaves D.J., Fillon M., "Analysis of a tilting pad journal bearing to avoid pad fluttering”, Int., vol. 40, 2007, pp. 607-612.
[20] Chatterton, S., Pennacchi, P., Dang, P. V., Vania, A., "A Test Rig for Evaluating Tilting–Pad Journal Bearing Characteristics”, Proc. 9th IFToMM International Conference on Rotor Dynamics, Milan, Italy, vol. 21, 2014.
Xem thêm
##plugins.themes.academic_pro.article.sidebar##
Đã Xuất bản
Dec 31, 2022
Download
Cách trích dẫn
Dang Phuoc Vinh. “Effect of Loaded-Pad Thickness on the Static Behaviors of Five-Pad Hydrodynamic Journal Bearings”. Tạp Chí Khoa học Và Công nghệ - Đại học Đà Nẵng, vol 20, số p.h 12.1, Tháng Chạp 2022, tr 15-19, doi:10.31130/ud-jst.2022.503E.
